洗衣機用水位壓力開關檢測

洗衣機用水位壓力開關檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

QB/T 1291-1991自動洗衣機用進水電磁閥

本標準規定了進水電磁間的產品分類、技術要求、試驗方法飛檢驗規則、標志、包裝、貯存和運輸。\t本標準適用于額定電壓為250V以下的全自動洗衣機和半自動洗衣機用電磁閥(以下簡稱“進水閣”)。

QB/T 1292-1991自動洗衣機用水位壓力開關

本標準規定了水位壓力開關的產品分類、技術要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存\t本標準適用于全自動洗衣機和半自動洗衣機用水位壓力開關(以下簡稱“開關”)，供控制水位高度用。

QB/T 1296-1991家用電冰箱用電熱線

本標準規定了家用電冰箱用電熱線的產品分類、技術要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存。\t本標準適用于單相交流50~60H z額定電壓不超過220v，以電阻材料為發熱源.力州關包覆軟性絕緣材料，供電冰箱化霜和輔助加熱用的線狀加熱元件(簡稱“電熱線”)。

SB/T 10865-2012家用電動洗衣機拆裝和維修服務技術規范

本標準規定了家用電動洗衣機拆裝和維修服務的術語和定義、技術要求、作業程序及質量測評方法。本標準適用于家用的波輪式、滾筒式、攪拌式或組合式電動洗衣機。

BS EN 806-2-2005人類消費用水的建筑物內部輸水設備規范.設計

This document gives recommendations, and specifies requirements, on the design of potable water installations within buildings and for pipework outside buildings but within the premises (see EN 806-1) and applies to new installations, alterations and repairs.

BS EN 14124-2004帶內溢流口的沖洗水箱用進水閥

The purpose of this document is to specify:? the dimensional, hygiene, tightness, pressure performance, hydraulic, acoustic, mechanical andphysico-chemical characteristics which inlet valves for flushing cisterns shall comply with;? the test methods for testing these characteristics;? marking and presentation.This document applies exclusively to the valve itself and it does not prejudge compliance with health regulations asthe inlet valve is being fitted into the cistern.This document does not cover valves intended to equip flushing cisterns with external overflow.This document applies to valves such as float valves limit operating at pressures up to NP 10 (whose operatingrange is from 0,05 MPa to 1 MPa – 0,5 bar to 10 bar) designed to supply cold water to flushing cisterns for use withWC pans, that are permanently connected to a potable water supply system.The working range can be extended downwards (< 0,05 MPa – 0,5 bar) down to 0,01 MPa (0,1 bar), in which casethe manufacturer’s instructions shall indicate this possibility as well as the recommended working range.Range which shall be coveredOptional rangeThis document does not apply to valves used for other applications: pumping tanks, storage tanks, etc.